Less aisle. More rack. Same building.
MiMA builds the trucks a standard forklift can’t replace — multidirectional machines for long loads, articulated trucks that work from the trailer into very narrow aisles, and reach and order-picker lines for high-density racking — 11 models across three families. Curated, spec’d to your building, and backed by local Carson service.
MiMA trucks are built to your configuration, so plan ahead. Start the conversation early and we’ll scope the right machine while the build slot is being reserved.
A note on the photos below: MiMA supplies photography by family rather than by model, so each image shows a representative truck of its type. Mast, forks, and cab on the unit we quote you are set by your configuration.
Narrow-aisle reach trucks for high-density pallet racking, extending the forks into the rack so aisles stay tight and the cube stays full. Configuration and capacity are scoped to your rack and aisle.
The flagship articulating truck: it works as a counterbalance forklift outside and an articulated very-narrow-aisle truck inside, so one machine moves loads from the trailer all the way into narrow racking.
An articulated truck with a quad full-free mast for low-headroom buildings, keeping full capacity where ceiling height is limited while still articulating into narrow aisles.
Stand-on multidirectional truck that drives sideways as well as forward, so long loads like timber, pipe, and board stock move through narrow aisles without swinging wide.
A heavier stand-on multidirectional truck for the same sideways travel, sized for the longer, denser loads that would overwhelm a lighter machine.
The heavy end of the multidirectional range, scaling to 17,600 lb for the largest long loads while still travelling sideways into narrow aisles.
A counterbalanced multidirectional truck that reaches loads directly with no outrigger legs, then turns sideways for long stock in tight aisles.
The higher-capacity counterbalanced multidirectional truck, pairing direct load reach with sideways travel for heavy long loads.
Seated multidirectional truck that keeps the operator comfortable over a full shift of long-load handling, with sideways and forward travel from one machine.
Seated 3-way pallet stacker for narrow-aisle stacking; forks rotate and shift laterally without body turning.
Order pickers that lift the operator to the pick face for fast, accurate case and each picking in narrow aisles. Pick height and platform configuration are matched to your racking on a scoped basis.
MiMA trucks are configured to the building, so the more you can tell us — aisle width, rack height, load type and length — the faster we can scope the right machine. Typical lead time is 12–16 weeks, so early is good.
Big Joe Assistant
Typically replies right away